Makeup How-Tos | ONLY MINERALS Official Website

How to Use

Put a small amount of foundation in the lid. Twist the brush in the lid to load it up with powder.
Place a pearl-sized amount of powder in the lid. This is enough to lightly cover the entire face.

Tap the loaded brush on the edge of the lid to remove any excess powder.
If there is too much powder on the surface of the brush, it is likely to result in an uneven coat. Load the brush again and tap to release the excess.

Move the brush in circles against the face, working from the center out towards the edges. For heavier coverage, repeat steps 1-3.
Press the brush firmly enough that you feel it spring against the skin. Draw small circles to apply, as if you're gently pulling up on the cheeks.

Repeat steps 1-3 two or three times for light coverage.
Repeat 5-6 times for heavier coverage.

Load foundation on the tip of the brush and press directly onto skin to apply. Adding a little extra foundation is the key to effective coverage.

Stand the brush vertically in the central net. Press down slightly to load it with foundation.
Use the area around the net to load the foundation deep into the brush while removing any excess.
Apply by moving the brush in small circles against the skin, working from the center out towards the edges. The key is pressing firmly with the center of the brush, as if you're massaging the skin.
Press the brush firmly enough that you feel it spring against the skin. Draw small circles to apply, as if you're gently pulling up on the cheeks.

Place the cut surface of the brush flat against the surface of the foundation. Gently tap the brush about five times to load it with foundation.

TIPS

If too much foundation gets in the brush, simply tap it once to release. The foundation will adhere evenly to the bristles.
Tap the foundation over the entire face as if you were applying a stamp, working from the center out towards the edges.

TIPS

Hold the brush vertically against the skin and tap firmly to get a quality finish.
Finish by sliding the brush over the face to even out the product.